SARGENT 53 - Latchbolt Monitor Switch User Manual
SARGENT Safety
A. Function
The 53- prefix latchbolt monitor switch provides positive indication of latchbolt
extension or retraction when the push rail is depressed, dogged or if the latch bolt
itself is depressed.
B. Important
1.
Caution:
Disconnect all input power before beginning installation to prevent electrical shock and
equipment damage.
2. Installer must be a trained, experienced service person.
3. All wiring must comply with applicable local electrical codes, ordinances and regulations.
C. ElectroLynx Connector System Notes:
The system is designed to be installation friendly with
quick connectors from the electric hinge through the
door to the rail. The only wiring required is to the
loose wires on the pigtail harness assembly on the
frame side of the electric hinge.
IMPORTANT:
The plug and receptacle connectors are designed to
mate and lock together as shown in the figure. Plug
the connectors into each other with the locking
mechanism aligned as indicated.
Do NOT force connectors on any other way.
1
53- 80 Series Rail with 8-pin connector
Green (NO)
Orange (NC)
White (C)
1
7
5
6 4
3
2
8
Plug
Locking mechanism
Receptacle
INSTALLATION INSTRUCTIONS
53- Prefix (Latch Monitor Switch) 80 Series
Exit Device to ElectroLynx™ Connector System
FOR INSTALLATION ASSISTANCE CALL SARGENT AT 800-810-WIRE (9473) • www.sargentlock.com
Copyright © 2009, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A7678B