Instructions for ce, le1 and te escutcheons – SARGENT 7900 Mortise Lock User Manual
Page 3
3
Instructions for CE, LE1 and TE Escutcheons
Through-bolt the inside escutcheon
to the outside escutcheon with
two screws #8-32 x 1-7/8"
Note: Screw heads should be visible
on inside escutcheon
Note: Removable Core or Interchangeable
Core cylinders - require a control key (key stamped
with “C”) to remove and install the inner cylinder
core. This is not provided standard; must be
requested separately. If requesting 1-Bitted
control key, specify 113511 cut.
Note: Cylinder collar(s) are
required for functions with
two cylinders or cylinders
longer than # 41 (1-1/8")
Inside of
door
Outside of
door
*** 130 KB thumb turn (designs vary) is used with rose trim
only, escutcheon trims requiring thumb turns, must be
preassembled at the factory
#41 Cylinder is standard for both single & double
cylinder functions for 1-3/4" thick door
NOTE: Trim one-side functions always require an inside
trim assembly which can be used on the inside or outside
of the door
How to Change Function of Lock:
Green catch screw must be located as designated on lock case
to create desired function.
3 locations: One for 05, 37 & 38 function (15 function in unlocked position)
One for 04, 06, 13, 17 & 31 functions
And one for 36 function
Note: When moving green catch screw to 04, 06, 13, 17 & 31 functions,
hub position must be at 45° as shown on lockcase.
*Note: 17 function requires both levers to be rigid. Rotate red
locking piece 90°, so red surface of slide faces back of lockbody.
*See How to Change Hand of Lock, page 4.
36
05
37
38
04 06 13 17 31
CHECK HUB
HUB
Items needed to create each of the following functions:
Type of Rose/Escutcheon
Kit Part Number
Trim one side kit
CO, CR, LN, O, TO & TR
82-3208
Trim one side kit
CE, LE1 & TE Escutcheon
82-3209
8200 Mortise Lock ONLY
Multi-function Lockbody Options
04, 05, 06, 13, 17, 31, 36, 37, 38
Function
Outside
Lever
Inside
Lever
Trim One
Side Kit
Outside
Cylinder
Inside
Cylinder
Thumb
Turn
04
X
X
X
05
X
X
X
X***
06
X
X
X
13
X
X
15
X
X
17
X
X
X
X
31
X
X
X
36
X
X
X
37
X
X
X
38
X
X
X
X
U.S. Patent (Pending) No. 5,678,870
Copyright © 2007-2008, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A7896B