SARGENT 7800 Knob Locks - Manual (Page 2)

Clean out lockbody pocket in edge of door to
assure it is clear of debris. For Triad Lock also
clear debris from hookbolt pockets and track
in edge of door.
Insert lockbody (and
hookbolts for Triad) into
door prep. Check that lock
fits easily in door with
screw holes aligned.
Secure lock to the door
using lockbody screws.
Do not tighten fully at
this time.
If a cylinder is not included your lock function, proceed to step 5
B. Insert spindle
into retaining
nut to secure
this position.
C. With outside lever/knob
in the horizontal
orientation, carefully
insert the mounting
posts through the
door and lockbody,
making sure the
spindle is engaged
in the lock. Outside
rose assembly should be
flush with door surface.
B. Secure cylinder in place by tightening the
cylinder retainer through hole in edge of
door (shown) with Phillips screwdriver.
C. Test cylinder for proper operation.
A. With outside rose
assembly in hand tighten
the retaining nut
against the mounting
plate as far as it will
go by hand. To insure
a tight fit in this
assembly, back off
retaining nut just one
notch, until star pattern
lines up with square
corners. (see pattern
shown)
B
C
A. With adapter and plate
assembly in hand repeat
step 3A and 3B as above.
B. Insert spindle with adapter
and plate into square hole
in lockbody on inside face
of door.
C. Secure adapter and plate
with thrubolt screws
making certain the lock
washers are attached
before tightening screws
into thrubolt post of the
outside rose assembly.
Do not over tighten.
A. Assemble cylinder into
spring first then into the
rosette with the flat edge
of rosette away from the
cylinder face to be mount
against the door face. Screw
cylinder with spring and
rosette assembled into lock-
body. Note: It is easier to use
a key, slightly out of position
in cylinder, to help screw the
cylinder down completely.
Note: This plate assembly will be circular in
shape on rose and LW1 trim
B
C
A
2
Copyright © 2009, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A7035E
The cylinder should only be screwed in so far that
it is flush with the rosette edge and SARGENT
logo is horizontally oriented. Over tightening
cylinder could cause malfunction in lock.
4
3
1
CHECK DOOR PREPARATION
INSTALL OUTSIDE ROSE ASSEMBLY
SECURE CYLINDER
2
INSTALL LOCKBODY
2
INSTALL INSIDE ADAPTER & PLATE ASSEMBLY
A 7035E 7800-8200:7800/8200 I.S. 5/20/09 2:10 PM Page 1