Wheatheart X Series 13 Augers - Manual (Page 116)

10. A PPENDIX W HEATHEART - X13 S ERIES A UGERS
10.2. B OLT T ORQUE V ALUES X1374, X1384, X1394
116 30787 R1
10.2. BOLT TORQUE VALUES
The tables shown below give correct torque values for various bolts and
capscrews. Tighten all bolts to the torque specified in the chart unless otherwise
noted. Check tightness of bolts periodically, using bolt torque chart as your guide.
Replace hardware with the same strength bolt.
Figure 10.1 Pattern for Tightening Wheel Bolts
Torque figures indicated above are valid for non-greased or non-oiled threads
and head unless otherwise specified. Therefore, do not grease or oil bolts or
capscrews unless otherwise specified in this manual. When using locking
elements, increase torque values by 5%.
Table 10.2 Imperial Bolt Torque
BOLT
DIAMETER
(Nm) (lb-ft) (Nm) (lb-ft) (Nm) (lb-ft)
1/4" 8 6 12 9 17 12
5/16" 13 10 25 19 36 27
3/8" 27 20 45 33 63 45
7/16" 41 30 72 53 100 75
1/2" 61 45 110 80 155 115
9/16" 95 60 155 115 220 165
5/8" 128 95 215 160 305 220
3/4" 225 165 390 290 540 400
7/8" 230 170 570 420 880 650
1" 345 225 850 630 1320 970