Wheatheart X Series 13 Augers - Manual (Page 57)

W HEATHEART - X13 S ERIES A UGERS 3. A SSEMBLY
X1374, X1384, X1394 3.13. A SSEMBLE W HEEL H UBS AND I NSTALL T IRES
30787 R1 57
3.13. ASSEMBLE WHEEL HUBS AND INSTALL TIRES
For each axle extension (29961) and hub assembly (17013) pair:
1. Remove any dirt from spindle and hub.
2. Thoroughly pack wheel bearings and cups with a good grade of bearing
grease.
3. Place large bearing into hub and carefully tap in seal.
4. Slip hub onto the axle extension spindle and insert small bearing and washer.
5. Tighten slotted spindle nut until hub drags slightly. Back off nut about 1/4 turn
until hub turns freely.
6. Install cotter pin and dust cap.
Note: Installing tires may not leave you with enough clearance to position and attach
undercarriage once auger tube is raised. If so, install wheels after assembly is
complete.
7. Inflate tires to recommendations on tire side wall. Wheels may be mounted
on hubs at this time using 6 wheel bolts.
8. Raise the three-piece axle, fully insert the axle extension and wheel, and
secure the axle extension with an axle pin (20008) and a 7/16”-3/4”, 1/8” DIA
hairpin (19463).

Figure 3.25 Wheel Hub Parts