Assembly, Tubes & flighting, Warning – Wheatheart WHR 80/100 x 31-71ft Augers PTO-SD User Manual

Page 19

Advertising
background image

WHEATHEART - GHR & WHR GRAIN AUGERS

3. A

SSEMBLY

PTO-SD D

RIVE

M

ODEL

3.1. T

UBES

& F

LIGHTING

30641 R1

19

3. Assembly

Before beginning assembly, familiarize yourself with all the sub-assemblies and
hardware making up the auger. Have all parts on hand and arrange them for
easy access. Carry out assembly in a large open area with a level surface.

Important:

Always have 2 or more people assembling the equipment. Because of the
weight, do not attempt assembly alone.

Augers are available in various combinations. In most cases, the following
instructions will apply to all augers. Where the assembly information varies,
additional instructions will be included and will be indicated with an arrow.

3.1. TUBES & FLIGHTING

1. Position tube sections. Align tube sections on a flat surface or on a series of

benches.

Figure 3.1

Note:

When assembling more than 2 sections, start from spout end and work towards
hopper.

2. Screw or slide lower flight shaft onto upper flight shaft until flight ends butt

together and flighting spiral matches up. Secure with hardware listed in table
below. Repeat, if necessary, for any remaining flight shafts.

WARNING Before continuing, ensure you have read and understand the relevant information
in the safety section. Safety information is provided to help prevent serious injury, death, or
property damage.

WARNING

Do not drop. Damage to equipment or serious
personal injury will result.

Advertising
This manual is related to the following products: