Wheatheart WHR 80/100 x 31-71ft Augers PTO-SD - Manual (Page 33)

WHEATHEART - GHR & WHR GRAIN AUGERS 3. A SSEMBLY
PTO-SD D RIVE M ODEL 3.13. T RANSPORT U NDERCARRIAGE
30641 R1 33
Note: Installing tires may not leave you with enough clearance to position and attach
undercarriage once auger tube is raised. If so, install wheels after assembly is
complete.
g. Check that pressure of pre-inflated tires matches pressure indicated on tire
sidewall. Mount wheels on hubs and attach with six 1/2” x 1-3/4” wheel
bolts.
6. Fasten upper lift arms to
lower reach arms with

5/8” x 1-1/2” bolts and
locknuts. Do not
overtighten. Tighten snug
only. These bolts act as
pivot points.
• The 8" x 56’-61’-71' and
the 10" x 51’-61’-71'
augers require 3/4” x 2"
bolts and locknuts.
7. Raise the discharge end of
auger with a front end loader and a strong
sling/chain or block and tackle. The height
should be sufficient to clear undercarriage
assembly.
8. Position transport undercarriage beneath tube assembly and attach lower
reach arms (Figure 3.17) or extension arms (6.) to reach arm bracket on
bottom tube with 5/8” x 1-1/2” bolts and locknuts. Do not overtighten.
Tighten snug only; these bolts act as pivot points.

• The 8" x 56’-61’-71' and the 10" x 51’-61’-71' augers require 3/4” x 2" bolts
and locknuts.
WARNING
Do not remove tube support until auger is fully
assembled.
Figure 3.16
