Intake hitch, Multi-stage driveshaft, Intake hitch 3.4. multi-stage driveshaft – Wheatheart WHR 80/100 x 31-71ft Augers PTO-SD User Manual

Page 22: Lower track stop, see table 3.2

Advertising
background image

3. A

SSEMBLY

WHEATHEART - GHR & WHR GRAIN AUGERS

3.3. I

NTAKE

H

ITCH

PTO-SD D

RIVE

M

ODEL

22

30641 R1

3.3. INTAKE HITCH

1. Clean dirt and paint

from lower flight stub
and intake bushing.

2. Attach intake hitch to

lower auger tube and
tighten securely.

3. Maintain 1/2” (1.27

cm) clearance
between bushing and
end of flight.

4. Attach clevis to intake

hitch with clevis pin
and gripclip.

3.4. MULTI-STAGE DRIVESHAFT

Because some sections of the driveshaft are factory installed, please consult the
table below for correct sequence before completing installation. Then proceed as
follows:

1. Clean paint and dirt from driveshaft end and shaft connectors.
2. Slide shaft connector halfway onto the last pre-installed driveshaft segment.

Table 3.2 Lower Track Stops

a

Auger

Length

From Int

a

ke

End

Lower Track Stop Locations

Welded

Trackstop

1st Hole

2nd Hole

31’

8”-10”

36’

8”

41’

8”-10”

46’

8”

51’

8”-10”

56’

8”

61’

8”-10”

71’

8”-10”

a. Count from the lower intake end of auger. For example, “1st Hole”

refers to the first set of holes in the lower end of the track nearest the
intake end.

Part

Size

Amt.

Intake Hitch

7/16” x 1” bolt and locknut

6

Clevis Pin

5/8” for 8”
3/4” for 10”

1

Figure 3.6

Advertising
This manual is related to the following products: