Wheatheart WHR 80/100 x 31-71ft Augers PTO-SD - Manual (Page 50)

6. M AINTENANCE & S TORAGE WHEATHEART - GHR & WHR GRAIN AUGERS
6.2. G ENERAL S TORAGE P ROCEDURES PTO-SD D RIVE M ODEL
50 30641 R1
6.2. GENERAL STORAGE PROCEDURES
T O PROTECT AUGER IN STORAGE DURING THE OFF - SEASON :
1. Lower the auger to full down position with slight tension on the cable.
2. Lubricate all grease fittings according to the maintenance procedure.
3. Inspect auger for damage and note any repairs required. Order replacement
parts from your dealer.
4. Check tire pressure and inflate if necessary. See tire sidewall for recommen-
dations.
5. Clean and re-lubricate spline on PTO driveline. Cover PTO driveline with
plastic bag to protect it from the weather and place in the transport saddle.
6. Tow auger to storage area. Park and chock wheels.
T O PREPARE AUGER FOR USE AFTER STORAGE :
1. Check tire pressure and inflate if necessary. See tire sidewall for recommen-
dations.
2. Tow auger to work site.
3. Remove cover from spline of PTO driveline and re-lubricate.
4. Check oil level in gearbox and refill if necessary (half full only).
5. Replace any damaged parts and decals.
6. Conduct general maintenance procedures before using auger.
7. Before raising auger after storage, make certain cable is in good condition,
replacing it if frayed or damaged. Also make sure cable is properly seated in
roller track and that cable clamps are secure.
8. On augers equipped with lubricated upper drive, check level of lubrication
annually and add as needed. Refill to plug level.
Winch
Note: Service
winch with auger in
fully lowered posi-
tion and cable
slack.
Keep a film of grease on gears. Regularly
Oil the ratchet pawl pivot, bushings, and pinion threads.
Do not get oil or grease on brake discs.
Occasionally
Replace brake discs if less than 1/16” (1.6 mm) thick. As required
Check for proper ratchet pawl operation.
When cranking in (clockwise) = loud clicking
When cranking out (counterclockwise) = no clicking and
ratchet pawl fully engaged into gear teeth
Regularly
Truss Cables Adjust to keep auger tube reasonably straight. As necessary
Area Maintenance Procedure Frequency
CAUTION
Support discharge end of auger before
removing or replacing any parts on the
undercarriage.