Great Plains 3S-4000F Predelivery Manual - Manual (Page 15)

9/12/2009 195-242Q
13 Setup
3. Bolt drill hitch onto drill tongue to match your
tractor-drawbar height. You can turn the hitch
over for a total of six different hitch heights.
NOTE: When hitching drill to a different tractor,
check for a difference in drawbar heights. If
heights are different, readjust hitch height accord-
ingly.
4. Securely attach safety chain to an anchor on
a tractor capable of pulling the drill.
5. Store jack on top of tongue as shown.
6. Plug drill electrical lead in tractor seven-pin
connector. If your tractor is not equipped with
a seven-pin connector, contact your dealer for
installation.
18956
18940