Great Plains 3S-4000F Predelivery Manual - Manual (Page 28)

3S-4000
195-242Q 9/12/2009
26
Refer to Figure 12.
3. To align the clutch jaws from front to rear,
loosen the two 1/2 inch carriage bolts (3) and
slide breakaway clutch (4) in the desired di-
rection.
4. To adjust clutch jaws for full jaw contact, loos-
en the two 1/2 inch carriage bolts (3) and slide
breakaway clutch (4) until jaws on the fixed
half of clutch make full contact with jaws on
spring loaded half of clutch without com-
pressing clutch spring.
NOTE: The two 7/8 inch hex shafts (5) should
have 1/8 inch between them when the clutch jaws
have full contact. Refer to Figure 13.
Figure 12
Transfer Drive Shaft Vertical Adjustment 18954
Figure 13
Hex Shafts
18955