Great Plains 3S-4000F Predelivery Manual - Manual (Page 27)

9/12/2009 195-242Q
25 Setup
Align Transfer Drive Shaft
After wing boxes are properly aligned, the transfer
drive shaft must be aligned so the pair of break-
away jaws are fully engaged and are concentric.
The 7/8 inch hex drive shafts holding the clutch
jaws should not contact each other when wing
boxes are properly aligned and back against their
stops.
1. Place a 4x4 or similar sized block ahead of
the wing gauge wheels and pull forward or
push wing box frames back until the toolbar is
firmly against toolbar stop bolts on the center
box frame.
2. Refer to Figure 11. To align the clutch jaws
vertically, loosen the two 5/8 inch bolts (1) on
the backside of the adjustment plate (2). Slide
the plate up or down in the desired direction.
Figure 11
Transfer Drive Shaft Vertical Adjustment
18953