Great Plains 3PYPA Predelivery Manual - Manual (Page 11)

Great Plains Manufacturing, Inc. Table of Contents Index Introduction 7
2012-08-08 Table of Contents Index 401-647Q
Shipment Inventory
The planter is shipped as the following 5 subassemblies
or kits:
Refer to Figure 3
1.
Main frame consisting of:
the complete tool bar with all the row units,
press wheels (two center units strapped on top),
air delivery system,
markers (if ordered),
parallel arms, and
gauge wheels (except on planters with 15 inch row
spacing).
Refer to Figure 4 (which depicts an optional seed hopper on
the seed structure)
2.
Rear Seed support structure consisting of
the frame, with
hydraulic steering components,
air distribution box,
caster mounts,
walkboard, and;
82 bushel hopper (if ordered).
Note: The optional hopper is mounted on the frame at
90 degrees from its operating orientation.
Refer to Figure 5
3.
Right and left caster assemblies including the
wheel hub and spindle assemblies. See “Caster
Arms” on page 23.
4. Rear lift assist wheels and tires (not shown).
Figure 3
Main Frame
29142
Figure 4
Rear Support Structure
31695
Figure 5
Caster Arms
31688