Great Plains 3PYPA Predelivery Manual - Manual (Page 17)

Great Plains Manufacturing, Inc. Table of Contents Index Plan The Mainframe Unload 13
2012-08-08 Table of Contents Index 401-647Q
Three Lift Points
Refer to Figure 13, Figure 15 and Figure 16
Using three lifters, position one (with the highest
capacity) at center frame rear, and lift via center frame
side tubes, as for single-lift (ref).
Position the other two lifters near, but not beyond, the
center-to-wing connection. Make sure both forks are
inboard, and lifting only the center section.
Unbalanced Load Risk:
Two observers are needed, one for front-back level, and the
other for side-to-side.
The observers need to pay close attention to planter level, and
signal each lift operator how to compensate if imbalance is
detected.
Figure 15
Three-lift points
25352
Figure 16
Front Side Lift Point
25353