Great Plains 3PYPA Predelivery Manual - Manual (Page 18)

14 3PYPA Table of Contents Index Great Plains Manufacturing, Inc.
401-647Q Table of Contents Index 2012-08-08
Four Lift Points
Refer to Figure 13, Figure 15, Figure 16 and Figure 18
Using four lifters, position one (with the highest capacity)
at center frame rear, and lift via center frame side tubes,
as for single-lift.
Position one lifter at the hitch, and lift via the cross-tube
of the hitch, as for 2-lift.
Position the other two lifters near, but not beyond, the
center-to-wing connection, as for 3-lift. Make sure both
forks are inboard, and lifting only the center section.
Unbalanced Load Risk:
Two observers are needed, one for front-back level, and the
other for side-to-side.
The observers need to pay close attention to planter level, and
signal each lift operator how to compensate if imbalance is
detected.
Figure 17
4-Lift Regions
25348
{
{
Figure 18
Four-lift in Progress
25354