John deere® tracked native sensor harness, John deere, Tracked native – Great Plains 3PYPA Predelivery Manual User Manual

Page 60

Advertising

3PYPA

Table of Contents

Index

Great Plains Manufacturing, Inc.

401-647Q

Table of Contents

Index

2012-08-08

John Deere

Tracked Native Sensor

Harness

Optional adaptor harness

for John Deere

tracked

tractors is necessary when the tractor wheel angle signal
cannot be obtained from the CANbus on the tractor.
Refer to Figure 94
75. Locate the Steering Angle Sensor

. It is mounted

on the bottom of the steering column, and is
accessible from the right side of the tractor just in
front of the cab.

Refer to Figure 96
76. Disconnect the sensor lead (not shown) and tractor

harness

Refer to Figure 95 and Figure 96
77. Reconnect the disconnected leads using the

adaptor harness

Refer to Figure 95
78. Route the sensor input lead

of the gray master

module harness

from the sensor module

the cab, to the adaptor harness

just installed at

step 77.

Mate the sensor input lead

to the sensor tap

lead

on the adaptor harness

79. Dress the sensor leads

and

along existing

harnesses, tubing, hoses and tractor fittings. Allow
slack near moving parts, routing through pivot
center-lines where possible. Avoid hot parts. Protect
the harness against strikes from brush and tall
stubble. Secure with cable ties.

Continue at “Install Module Output Harness” on
page 58.

Figure 94

John Deere

Tracked Tractor

Steering Sensor Location

31850

Figure 95

John Deere

Tracked Tractors

Adaptor Harness

31837

73a