Great Plains 2S-2600HDF Operator Manual v1 - Manual (Page 83)

Great Plains Manufacturing, Inc. Table of Contents Index Maintenance and Lubrication 79
2014-05-16 Table of Contents Index 195-440M
Small Seeds Box Clean-Out
1. Open box lid and scoop out as much seed as
possible.
2. To recover remaining seed, place a collection tarp
under the small seeds tubes at the openers.
3. Raise drill.
4. Set seed rate handle to 100.
5. Rotate calibration crank or end wheel until no seed
flows.
6. If a vacuum cleaner is available, remove any residual
seed from top of meters.
Seed Flap Replacement
Refer to Figure 90
To replace an 816-302C seed flap
use a needle nose
pliers or similar tool to grasp “T” top of flap. Pull upward
to pull flap up out of metal bracket
.
Push new seed flap down through metal bracket
until flap snaps into place with “T” top resting on top of
bracket.
4
Figure 90
816-302C Seed Tube Flap
31047
5
4
5
4 5