Great Plains YP1625 Operator Manual - Manual (Page 78)

1625
401-182M 7/12/2005
76
Figure 77
Figure 78
Figure 79
Refer to Figure 77
1. Press Function key until the Calibration win-
dow appears as shown.
2. Press up arrow key to enter calibration mode.
Refer to Figure 78
3. This is the first window that appears in Cali-
bration mode. Press Function key to accept,
or Up key to change to metric settings.
Refer to Figure 79
4. Enter drill width here using Up/Down arrow
keys. Press Function key to advance to next
window.
22718
22717
22779