Great Plains 3S-3000F Operator Manual v2 - Manual (Page 15)

13
Section 1 Drill Preparation and Setup
11/9/07 3S-3000 Three-Section Folding Drill 195-110M-A
Great Plains Mfg., Inc.
1. Adjust The Wing Box Alignment
Refer to Figure 1-5, place a 4x4 or similar sized block
ahead of the wing gauge wheels. Pull forward or rock the
wing frames back until the toolbar stop bolt is firmly
against the stop plate on the center box frame. The toolbar
stop bolt runs through a formed channel on the bottom
side of the toolbar. Run a string line across the back of the center box and out toward the outer ends of the wings.
The outboard ends of the wing boxes should be toed for-
ward about 1" ahead of the inboard ends. Adjust the wing
box alignment by controlling when the 1 1/4" toolbar stop
bolt contacts the stop plate on the center box frame. Ad-
just the 1 1/4" toolbar stop bolts in or out until the outer
end of the wing boxes are toed forward about 1".
Wing Box Alignment Measurement
Figure 1-5
15654
15655
Stop Bolt
String Line String Line
Support String Line
Support
A A B
C C
B
C-B=1" C-B=1"