Great Plains 3S-3000HDF Operator Manual v2 - Manual (Page 81)

Great Plains Manufacturing, Inc. Table of Contents Index Maintenance and Lubrication 77
2014-02-11 Table of Contents Index 195-068M
Align Transfer Drive Shaft
Refer to Figure 82 and Figure 83
After wing boxes are properly aligned, the transfer drive
shaft must be aligned so the pair of break-away jaws
are fully engaged and are concentric. The
7 ⁄
8
in hex drive
shafts holding the clutch jaws should not contact each
other
when wing boxes are properly aligned and back
against their stops.
1. Place a 4x4in (10x10cm) or similar sized block
ahead of the wing gauge wheels and pull forward or
push wing box frames back until the tool bar is firmly
against tool bar stop bolts on the center box frame.
2. To align the clutch jaws vertically, loosen the two
5 ⁄
8
inch bolts securing the bearing flangettes .
Slide the flangettes in the desired direction. Tighten
bolts.
FigureSpacer
Figure 82
Transfer Drive Jaws
18955
1
2
3
4
FigureSpacer
Figure 83
Transfer Drive Shaft Front-Back Adjustment
15620
3
4
1
2
3 4