Great Plains 3S-3000HDF Operator Manual v2 - Manual (Page 82)

78 3S-3000HD Table of Contents Index Great Plains Manufacturing, Inc.
195-068M Table of Contents Index 2014-02-11
Refer to Figure 84 and Figure 85
3.
To align the clutch jaws vertically, loosen the two
5 ⁄
16
inch bolts at the bottom of the breakaway
clutch bracket , and adjust the bracket as needed.
4. To adjust clutch jaws for full jaw contact, loosen the
two
5 ⁄
16
inch carriage bolts and slide breakaway
clutch bracket until jaws on the fixed half of clutch
make full contact with jaws on spring loaded half of
clutch without compressing clutch spring.
Note: The two 7 ⁄
8
inch hex shafts should have 1 ⁄
8
inch
(3.2mm) gap between them when the clutch
jaws have full contact.
FigureSpacer
Figure 84
Transfer Drive Shaft Gap
18955
2
1 7 7
FigureSpacer
Figure 85
Transfer Drive Shaft Vertical and Left-Right Adjustment
15621
6
5
7
7
8
9
1
5
6
8
9
7
2