Great Plains Swath Command Section Control - Manual (Page 19)

2012-08-23 Table of Contents Index 402-382M
Great Plains Manufacturing, Inc. Table of Contents Index 15
Install Compressor
Compressor installation varies by hitch type:
Hydraulic Tongue (H.T.) Compressor
Installation
Refer to Figure 12
If the hydraulic tongue already has a compressor mount
bracket
available, continue at “Install Compressor
Mount (H.T.)” on page 16.
Note: 2012 and later hydraulic tongues have these
brackets. Earlier tongues do not, and must be
upgraded with parts purchased separately (see
parts list in step 97).
Install H.T. Mount Bracket(s)
Swath Command™ kits do not include mount brackets.
The necessary parts are presumed to have been
separately ordered.
Prepare H.T. Hitch Weldment
Refer to Figure 13 (showing right side of hitch)
Note: By convention the Swath Command™ compressor
is installed on the right side of the hitch. The
second mount bracket, on the left side, would be
used for a Row-Pro™ compressor.
95. Mark and center-punch locations as shown near the
leading right edge of the hitch weldment. If two sets
of mount brackets are on hand, mark holes on the
left side as well (also near leading edge).
96. Use a pilot bit and a
17 ⁄
32
inch (13.5 mm) bit to
create two or four holes.
Affix H.T. Bracket(s)
Refer to Figure 12 and Figure 13
97. Select one or two:
404-228D HYD HITCH COMP MOUNT BRACKET
and two or four sets:
802-091C HHCS 1/2-13X1 1/2 GR5
804-015C WASHER LOCK SPRING 1/2 PLT
803-020C NUT HEX 1/2-13 PLT
Position each bracket forward of the hitch
weldment. Insert a bolt from the outside. Secure
with lock washers and nuts .
Pull Type, Hydraulic Tongue: below
Pull Type, Three-Point:
page 17
3PYP/A Three-Point: page 18
Figure 12
H.T. Compressor Mount Check
34072
209
U
D
F
B
L
R
239
227
246
209
Figure 13
H.T. Mount Hole Locations
34073
13
3
⁄ 4
in. (34.9
cm)
17
1
⁄ 4
in. (43.8
cm)
∅
17
⁄ 32
in.
(13.5
mm)
1.0 in. (25.4 mm)
U
D
B F
209
227
246
239
209
227
246 239