Great Plains Swath Command Section Control - Manual (Page 21)

Great Plains Manufacturing, Inc. Table of Contents Index Install Compressor 17
2012-08-23 Table of Contents Index 402-382M
Pull-Type 3-Point Compressor
Installation
Note: By convention, the Swath Command™
compressor is installed on the right hand side of the
hitch. If a Row-Pro™ compressor is already
installed there, the Swath Command™
compressor may be installed on the left hand side.
Refer to Figure 16
105. Select one each new:
404-861H 12V COMP MOUNT WELDMENT
806-060C U-BOLT 1/2-13 X 6 1/32 X 7 1/4
and two sets:
804-016C WASHER FLAT 1/2 SAE PLT
804-015C WASHER LOCK SPRING 1/2 PLT
803-020C NUT HEX 1/2-13 PLT
Place the U-bolt on the 3-point hitch cross-tube, to
the right of the center riser. Loosely secure the
mount weldment
with flat washers , lock
washers and nuts . Adjust mount position so
that the left edge of the platform clears the riser by
approximately an inch (5 cm).
106. If the side covers ( and ) and top are
pre-installed on the mount weldment , and the
compressor is not pre-installed, remove the covers,
saving the fasteners.
Install Compressor (3P)
107. Select one:
823-330C TRU-COUNT COMPRESSOR ASSEMBLY
Orient the compressor assembly so that the valve
is to the front. Secure it to the platform of the mount
weldment
using the fasteners provided.
Install Compressor Covers (3P)
108. Select one:
404-226D TC COMPRESSOR COVER SIDE R
Orient the side cover with the access port at
the valve . Loosely secure cover to mount with
provided fasteners.
109. Select one:
404-227D TC COMPRESSOR COVER SIDE L
Loosely secure cover to mount with provided
fasteners.
110. Select one:
404-225D 12 COMPRESSOR COVER TOP
Completely secure top to side covers with provided
fasteners.
111. Continue at “Install Valve Blocks” on page 19.
Figure 16
Pull-Type 3-Point Mount
34076
U
D
F
B
L
R
1
206
211
254
2
208
263
207
247
246
239
211
254
247
246
239
211 247
246 239
207 208 206
211
263
1
211
207
207 2
1
208
206