Great Plains Swath Command Section Control - Manual (Page 28)

402-382M Table of Contents Index 2012-08-23
24 Swath Command™ Table of Contents Index Great Plains Manufacturing, Inc.
Install Harness
Determine Connections
146. Find the Clutch Layout for your planter model
(these are on page 48 through page 132).
Determine which valve is attached to which
WSMB-TCOM
, and which outputs of the
WSMB.
Refer to Figure 23 (which is a generalized layout, and not
specific to any particular kit)
Connect WSMB Harnesses
Insert Left Wing WSMB Harness
147. On the left wing, locate a CANbus connection
near the first WSMB-TCOM . This connection
may be from the hitch lead, at the WSMT, or at an
existing WSMB.
148. Select one new:
467983505 DJIA OUTPUT HARN 8-CH TRU-COUN
Interconnect the four CANbus connectors into the
existing harness.
Connect the DEUTSCH connectors to the
WSMB-TCOM
.
Insert Right Wing WSMB Harness
If your kit only had one WSMB, continue at “Connect
Valve Blocks” on page 25.
149. On the right wing, locate a CANbus connection
near the second WSMB-TCOM . This
connection may be at an existing WSMB, but is
more likely to be at the CANbus terminator
.
150. Select one new:
467983505 DJIA OUTPUT HARN 8-CH TRU-COUN
Interconnect the four CANbus connectors into the
existing harness. In the case of a terminator
connection, one harness connector is left
unconnected, and the other on that side takes the
terminator.
Connect the DEUTSCH connectors to the
WSMB-TCOM
.
WSMB
Tru Count
Output Module
Tru Count
Clutch Harness
467983505
WP6 Extension
WSMB
Tru Count
Output Module
Tru Count
Clutch Harness
467983505
Tru Count
Solenoid
Module
Tru Count
Solenoid
Module
Tru Count
Solenoid
Module
CAN
Terminator
Figure 23
Generalized Implement Harness Diagram
34246
272
272
272
218 218
18
219 219
1 2
264 265
218
1
218
219
218
1
218
18
219
218