Great Plains Swath Command Section Control - Manual (Page 22)

18 Swath Command™ Table of Contents Index Great Plains Manufacturing, Inc.
402-382M Table of Contents Index 2012-08-23
3PYP and 3PYPA Compressor
Installation
Note: By convention, the Swath Command™
compressor is installed on the right hand side of the
hitch. If a Row-Pro™ compressor is already
installed there, the Swath Command™
compressor may be installed on the left hand side.
Refer to Figure 17
112. Select two each new:
806-052C U-BOLT 5/8-11 X 7 1/32 X 8 1/2
and two:
404-230D COMPRESSOR MOUNT BRACKET
(or the complete mount assembly, if pre-assembled)
and four sets:
804-022C WASHER LOCK SPRING 5/8 PLT
803-021C NUT HEX 5/8-11 PLT
Find a location on the opener tool bar, right of the
hitch, where the mount assembly clears other
machine parts in front, and the brackets
seat
fully against the bottom of the tool bar.
Secure the mount weldment with U-bolts ,
lock washers and nuts .
113. If the side covers ( and ) and top are
pre-installed on the mount assembly, and the
compressor is not pre-installed, remove the covers,
saving the fasteners.
Install Compressor (3PYP)
114. Select one:
823-330C TRU-COUNT COMPRESSOR ASSEMBLY
Orient the compressor assembly so that the valve
is to the front. Secure it to the platform of the mount
weldment
using the fasteners provided.
Install Compressor Covers (3PYP)
115. Select one:
404-226D TC COMPRESSOR COVER SIDE R
Orient the side cover with the access port at
the valve . Loosely secure cover to mount with
provided fasteners.
116. Select one:
404-227D TC COMPRESSOR COVER SIDE L
Loosely secure cover to mount with provided
fasteners.
117. Select one:
404-225D 12 COMPRESSOR COVER TOP
Completely secure top to side covers with provided
fasteners.
Figure 17
3PYP Compressor Mount
34077
U
D
F
B
L
R
1
263
253
207
2
210
248
240
253
210
248
240
210
211 253
246 239
207 208 206
263
1
211
207
207 2
1
208
206