Bio-Rad BioLogic LP System - Manual (Page 7)

Section 4
System Setup
1. Assemble the rack as shown in Figure 1. Be sure to install the rack
tray drain fitting, and provide a drain tube in case of spills.
Fig. 1.
2. Position the UV monitor optics module, proportioning valve/mixer,
conductivity flow cell/column holder, etc. on the rack. The plumbing
diagram shown in Figure 5 will help you determine the best positions
for components. Lead all cables toward the rear of the unit.
3. Connect cables from UV optics module, conductivity flow cell,
proportioning valve/mixer, and valves to the appropriate receptacles
on the rear panel of the BioLogic LP as shown in Figure 2.
Drain
Tubing
Side View
See Detail
Column
Clamping
Set
Tapered
Collar
Tray
Drain
Fitting Horizontal
Bar
3
4006073D.qxp 8/17/2009 7:45 AM Page 3