Validating your configuration – Motorola 3347 User Manual

Page 190

Advertising
background image

190

then enter the configuration values appropriate for your site without having to enter com-
plete CLI commands.

When you are in step mode, the command line inter face prompts you to enter required and
optional settings. If a setting has a default value or a current setting, the command line
inter face displays the default value for the command in parentheses. If a command has a
limited number of acceptable values, those values are presented in brackets, with each
value separated by a ver tical line. For example, the following CLI step command indicates
that the default value is

off

and that valid entries are limited to

on

and

off

.

option (off) [on | off]:

on

You can accept the default value for a field by pressing the Return key. To use a different
value, enter it and press Return.

You can enter the CONFIG step mode by entering

set

from the top node of the CONFIG hier-

archy. You can enter step mode for a par ticular ser vice by entering

set

service_name

.

In stepping set mode (press Control-X <Return/Enter> to exit. For example:

Netopia-3000/9437188 (top)>> set system

...

system

name (“Netopia-3000/9437188”): Mycroft

Diagnostic Level (High): medium

Stepping mode ended.

Validating Your Configuration

You can use the

validate

CONFIG command to make sure that your configuration set-

tings have been entered correctly. If you use the

validate

command, the Motorola

Netopia® Gateway verifies that all required settings for all ser vices are present and that
settings are consistent.

Netopia-3000/9437188 (top)>> validate

Error: Subnet mask is incorrect

Global Validation did not pass inspection!

You can use the

validate

command to verify your configuration settings at any time.

Your Motorola Netopia® Gateway automatically validates your configuration any time you
save a modified configuration.

Advertising