Motorola 3347 - Manual (Page 237)

237
CONFIG Commands
SIP Passthrough
set ip sip-passthrough [ on | off ]
Turns Session Initiation Protocol application layer gateway client passthrough on or off.
The default is
on.
Session Initiation Protocol, is a signaling protocol for Internet conferencing, telephony,
presence, events notification and instant messaging.
RTSP Passthrough
set ip ethernet B rtsp-passthrough [ off | on ]
Turns Real Time Streaming Protocol application layer gateway client passthrough on or off.
RTSP is a protocol used for streaming media. It allows a client remotely to control a
streaming media ser ver. A typical application is Video-on-Demand (VoD). The default is
on.
Static Route Settings
A static route identifies a manually configured pathway to a remote network. Unlike
dynamic routes, which are acquired and confirmed periodically from other routers, static
routes do not time out. Consequently, static routes are useful when working with PPP,
since an intermittent PPP link may make maintenance of dynamic routes problematic.
You can configure as many as 32 static IP routes for a Motorola Netopia® Gateway. Use
the following commands to maintain static routes to the Motorola Netopia® Gateway rout-
ing table:
set ip static-routes destination-network net_address
Specifies the network address for the static route. Enter a network address in the
net_address argument in dotted decimal format. The net_address argument cannot
be 0.0.0.0.