Set or change the network password, Ip address, Link speeds and duplex settings – HP Laserjet p1606dn User Manual
Set or change the network password
Use the embedded Web server to set a network password or change an existing password.
Open the embedded Web server, click the Networking tab, and click the Password link.
If a password has previously been set, you are prompted to type the password. Type the
password, and then click the Apply button.
Type the new password in the Password box and in the Confirm Password box.
At the bottom of the window, click the Apply button to save the password.
The product IP address can be set manually, or it can be configured automatically using DHCP, BootP,
To change the IP address manually, use the Networking tab in the HP Embedded Web Server.
Link speeds and duplex settings
In this section duplex refers to bi-directional communication, not two-sided printing.
Use the Networking tab in the embedded Web server to set the link speed if necessary.
Incorrect changes to the link speed setting might prevent the product from communicating with other
network devices. For most situations, leave the product in automatic mode. Changes can cause the
product to turn off, and then on. Make changes only when the product is idle.
Chapter 4 Connect the product