HP Laserjet p1606dn - Manual (Page 111)

Misformed characters
● If characters are improperly formed, producing hollow
images, the media stock might be too slick. Try a
different media.
● If characters are improperly formed, producing a wavy
effect, the product might need service. Print a
configuration page. If the characters are improperly
formed, contact an HP-authorized dealer or service
representative.
Page skew
● Make sure that the media is loaded correctly and the
media guides are not too tight or too loose against the
media stack.
● The input bin might be too full.
● Check the media type and quality.
Curl or wave
● Check the media type and quality. Both high temperature
and high humidity cause media to curl.
● The media might have been in the input tray too long.
Turn over the stack of media in the tray. Also, try rotating
the media 180° in the input tray.
● Place the product in quiet mode, and send the print job
again. See
Quiet mode settings on page 59 .
● The fuser temperature might be too high. In your printer
driver, make sure the appropriate media type is selected.
If the problem persists, select a media type that uses a
lower fuser temperature, such as transparencies or light
media.
ENWW Solve image-quality problems 99