Integra LifeSciences Mirror, DenLite Illuminate - Manual (Page 7)

-Page 7 of 14-
1. Place the batteries inside the handle base with the positive (+) terminal facing upward.
2. Insert the LED Light Cartridge into the handle base.
3. Screw the collet onto the handle base to the off position (first click).
4. Attach the collet ring (1 turn) onto the collet.
5. Insert the Single-use Mirror inside the collet ring and tighten.
Using the DenLite Illuminated Dental Mirror
1. Fully tighten the collet assembly and the LED Light Cartridge will illuminate.
2. Loosen the collet assembly to the detent position and the LED Light Cartridge will
extinguish.
3. Remove and properly dispose of the Single-Use Mirror after each use.
4. Sterilize the DenLite handle, collet and collet ring after each use, page 11. If the
DenLite instrument is dropped at anytime:
• Use a new handle assembly and a new mirror.
• Properly dispose of the dropped mirror.
• Re-sterilize the handle assembly.
Maintenance
Handle Assembly
Before each use, check the handle assembly for cracks and/or other imperfections.
Replace the handle assembly as necessary (part number DP5200).
Battery Replacement
If the lamp does not illuminate or is dim, replace the batteries.
1. Remove the collet assembly.
2. Remove the LED Light Cartridge.
3. Remove the batteries from the handle assembly and replace with fully charged
batteries. Only use I-C 3 , NiMH, or NiCd as replacement battery types.
4. Reassemble the DenLite Illuminated Dental Mirror, page 6.
In the USA, call 1-800-SAV-LEAD for instructions on how to recycle batteries. This device is
subject to EU Directive 2002/96/EC (WEEE). It is not registered for use in private households,
and may not be disposed of at municipal collection points for waste electrical and electronic
equipment. For users outside the United States, contact your local authorities on recycling
procedures.
Dispose of Properly