Vermont Casting DBT36 - Manual (Page 16)

DBT33/DBT36/DBT39 -16- 10002789/0
• 7DVCS must be used to support offsets. (Fig. 36)This
application will require that you rst determine the roof
pitch and use the appropriate starter kit. (See Venting
Components List)
• The minimum height of the vent above the highest point
of penetration through the roof is 2'. See Fig. 38.
V
ERTICAL
R
ESTRICTOR
P
LATE
(DBT33
ONLY
)
When installing the DBT33 with a Vertical Through-The-Roof
congured ue system the restrictor plate, (#10002495) sup-
plied with the appliance MUST BE FITTED TO THE
APPLIANCE at installation.
Fitting The Restrictor Plate
1. Remove the window glass/frame assembly.
2. Locate the rebox bafe assembly in the top rear area of
the rebox, Fig. 32.
3. Remove the four (4) nuts along the front edge, and the
three (3) screws along the rear edge of the bafe assembly.
Remove the bafe assembly from the rebox.
4. Remove the two (2) screws from the top face of the bafe
assembly, Fig. 32. Place the restrictor plate as shown in
Fig. 34 and secure by retting the screws.
5. Ret the bafe assembly to the rebox, replacing the three
(3) screws and four (4) nuts.
6. Ret window glass/frame as per the appropriate sections
of this manual.
Fig. 31
Fig. 32
Fig. 33
Fig. 34