Scanning for a wireless network, Enabling the network locator – Dell Studio 1558 (Early 2010) User Manual

Page 167

Advertising
background image

Networks (LAN, Wireless, Mobile Broadband)

167

The wireless switch uses the Dell Wi-Fi Catcher Network Locator to scan
specifically for wireless networks in your vicinity.

Scanning for a Wireless Network

On some computers, you can use the wireless switch to scan for wireless
networks in your vicinity. To scan for a wireless network, slide and hold the
wireless switch in position for a few seconds (see "Enabling/Disabling the
Wireless Card With a Wireless Switch" on page 157).

Other computers may use a separate button or switch for scanning. Follow
the instructions in the documentation for using the wireless switch or button.

The Wi-Fi Catcher Network Locator functions regardless of whether your
computer is turned on or off, or in a sleep mode, as long as the switch is
enabled and configured to control Wi-Fi network connections.

NOTE:

The light turns on only when the computer is turned off.

Enabling the Network Locator

Because the Wi-Fi Catcher Network Locator may be disabled and not
configured for use when your computer is shipped to you, you must first
enable and configure the switch to control Wi-Fi network connections. You
can accomplish this task through:

Dell ControlPoint Connection Manager

System BIOS, available through the system setup program (see "System
Setup" on page 307)

Dell ControlPoint Connection Manager

You can access the Dell ControlPoint Connection Manager from the Dell
ControlPoint (DCP) application.

DCP icon

Advertising