Dell Studio 1558 (Early 2010) - Manual (Page 277)

Troubleshooting
277
( VALUE ) — See "Lockups and Software Problems" on page 292.
M EMORY DOUBLE WORD LOGIC FAILURE AT ( ADDRESS ) , READ VALUE EXPECTING
( VALUE ) — See "Lockups and Software Problems" on page 292.
M EMORY ODD / EVEN LOGIC FAILURE AT ( ADDRESS ) READ VALUE EXPECTING
( VALUE ) — See "Lockups and Software Problems" on page 292.
M EMORY WRITE / READ FAILURE AT ( ADDRESS ) , READ VALUE EXPECTING
( VALUE ) — See "Lockups and Software Problems" on page 292.
M EMORY SIZE IN CMOS INVALID — See "Lockups and Software Problems" on
page 292.
N O BOOT DEVICE AVAILABLE – STRIKE F 1 TO RETRY BOOT , F 2 FOR SETUP UTILITY .
PRESS F 5 TO RUN ONBOARD DIAGNOSTICS — The system cannot detect a bootable
device or partition.
• If the optical drive is your boot device, ensure that the cables are connected and that
a bootable optical media is in the drive.
• If the hard drive is your boot device, ensure that the drive is installed properly and
partitioned as a boot device.
• Enter the system setup program and ensure that the boot sequence information is
correct (see "Entering the System Setup Program" on page 308).
N O BOOT SECTOR ON HARD - DISK DRIVE — Enter the system setup program and
ensure that the configuration information for the hard drive is correct (see "Entering
the System Setup Program" on page 308).
N O TIMER TICK INTERRUPT — Run the Dell Diagnostics (see "Running the Dell
Diagnostics" on page 281).
P OWER WARNING MESSAGES HAVE BEEN DISABLED . RUN THE SETUP UTILITY TO
ENABLE THESE MESSAGES . — See "Entering the System Setup Program " on
page 308.
R EAD FAILURE ON INTERNAL HARD DRIVE — See "Drive Problems" on page 287.
R EAD FAILURE ON SECOND INTERNAL HARD DRIVE — This message applies to
notebook computers that support multiple hard drives. See "Drive Problems" on
page 287.
R T C MODE FIXED – TIME AND DATE MAY BE WRONG — Enter the system setup
program and correct the date or time (see "Entering the System Setup Program" on
page 308). If the problem persists, replace the CMOS battery.
S HUTDOWN FAILURE — Run the Dell Diagnostics (see "Running the Dell
Diagnostics" on page 281).
T IME - OF - DAY CLOCK STOPPED – PLEASE RUN THE SYSTEM SETUP