Dell 3100cn Color Laser Printer - Manual (Page 179)

Port Settings
Purpose:
To specify whether to enable or disable printing ports and management protocol features.
Values:
*1 An optional multi protocol card is required to use.
TCP/IP
Purpose:
To configure the IP address, subnet mask, and gateway address of the printer.
Values:
Auto Refresh Interval Sets the time interval for refreshing the contents of the status display pages automatically from 15 to 600
seconds.
NOTE: The auto refresh feature is effective for the contents of the Top Frame, Printer Status page, Job List page, and Completed Jobs page.
Ethernet Ethernet
Settings Auto Detects Ethernet transmission rate and the duplex settings automatically.
10BASE-T Half-
Duplex Selects 10Base-T Half-Duplex as the default value.
10BASE-T Full-
Duplex Selects 10Base-T Full-Duplex as the default value.
100BASE-TX Half-
Duplex Selects 100Base-T Half-Duplex as the default value.
100BASE-TX Full-
Duplex Selects 100Base-T Full-Duplex as the default value.
Current Ethernet Settings Displays the current settings of Ethernet.
MAC Address Displays the printer's MAC address.
Port
Settings LPD Select the check box to enable the LPD.
Port9100 Select the check box to enable the Port9100.
IPP* 1 Select the check box to enable the IPP port.
FTP Select the check box to enable the FTP port.
SMB* 1 Select the check box to enable the SMB.
You can also configure the transport protocol to be used. TCP/IP and NetBEUI can be selected
simultaneously as the transport protocol.
NetWare* 1 Select the check box to enable the NetWare port.
AppleTalk* 1 Select the check box to enable the AppleTalk port.
E-Mail Alert Select the check box to enable the E-Mail Alert feature.
SNMP Agent Select the check box to enable the SNMP.
You can also configure the transport protocol to be used. UDP and IPX can be selected simultaneously
as the transport protocol.
IPX is only available when the multiprotocol card is installed.
NOTE: The settings in the Port Settings item will be valid only when the printer is rebooted. When you change or set this item, click the Restart printer
to apply new settings. button to apply new settings.
TCP/IP
Settings Host Name Specifies the host name up to 15 alphanumeric characters. The default name will remain valid if no entry is made.