Dell 3100cn Color Laser Printer - Manual (Page 98)

This option converts text to single-byte text and sets printing to start from the nth column.
-y outline=n
Sets printing to start from the nth line.
-y font=font
Sets the font for printing single-byte alphanumeric characters. If the font specified is not available for the printer, the default fonts are used.
-y margin=u:b:r:l
Specifies the margin of a page in inches. The u (upper margin), b (bottom margin), r (right margin), and l (left margin) are positive real numbers (up
to two decimal points). The default is 0.
To print text/PostScript files:
-y DuplexBook
Enables the long-edge binding feature. When it is specified, the printing direction or position will be adjusted and both sides of the paper printed
so that the longer edge of the pages can be bound.
-y DuplexList
Enables the short-edge binding feature. When it is specified, the printing direction or position will be adjusted and both sides of the paper printed
so that the shorter edge of the pages can be bound.
-y tray-input
The paper tray-related parameters that can be specified by the lp command are as follows.
tray1
Feed paper from tray 1 (standard 250-sheet tray module).
tray2
Feed paper from tray 2 (optional 250-sheet tray module or 500-sheet tray module).
a4
Feed paper from the tray loaded with A4 (210 x 297 mm).
a5
Feed paper from the tray loaded with A5 (148 x 210 mm).
b5
Feed paper from the tray loaded with B5 (182 x 257 mm).
letter
Feed paper from the tray loaded with Letter (8.5 x 11 inches).
folio
Feed paper from the tray loaded with Folio (8.5 x 13 inches).
legal
Feed paper from the tray loaded with Legal (8.5 x 14 inches).
executive
Feed paper from the tray loaded with Executive (7.25 x 10.5 inches).
monarch
Feed paper from the tray loaded with Monarch (3.875 x 7.5 inches).
com10
Feed paper from the tray loaded with Envelope #10 (4.125 x 9.5 inches).
dl
Feed paper from the tray loaded with DL (110 x 220 mm).
c5
Feed paper from the tray loaded with C5 (162 x 229 mm).
MxNmm
Feed paper from the tray loaded with MxNmm defined by users.
Possible range specified:
Width: 90.0 to 215.9 mm
Length: 139.7 to 355.6 mm
MxNin
NOTE: To specify a font, type the font name as-is after the -y font= option.
% lp -y font=Courier-Oblique filename
NOTE: For information on the available fonts, see the PS Fonts List.
NOTE: When you specify com 10, MxNmm or MxNin and so on, also specify the -y msi option.