Dell PowerVault NX3200 - Manual (Page 15)

Figure 6. DC Power Supply Status Indicator
1. DC power supply status indicator
Power
Indicator
Pattern Condition
Not lit Power is not connected.
Green The handle/LED indicator lights green indicating that a valid power source is connected to the power
supply and that the power supply is operational.
Flashing
amber Indicates a problem with the power supply.
CAUTION: When correcting a power supply mismatch, replace only the power supply with the
flashing indicator. Swapping the opposite power supply to make a matched pair can result in an
error condition and unexpected system shutdown. To change from a High Output configuration to a
Low Output configuration or vice versa, you must power down the system.
CAUTION: AC power supplies support both 220 V and 110 V input voltages. When two identical
power supplies receive different input voltages, they can output different wattages, and trigger a
mismatch.
CAUTION: If two power supplies are used, they must be of the same type and have the same
maximum output power.
CAUTION: Combining AC and DC power supplies is not supported and triggers a mismatch.
Flashing
green When hot-adding a power supply, this indicates that the power supply is mismatched with the other
power supply (in terms of efficiency, feature set, health status, and supported voltage). Replace the
power supply that has the flashing indicator with a power supply that matches the capacity of the
other installed power supply.
Other Information You May Need
WARNING: See the safety and regulatory information that shipped with your system. Warranty information may be
included within this document or as a separate document.
15