Installing the network daughter card, Processors – Dell PowerVault NX3200 User Manual
Page 71
Figure 34. Removing and Installing the Network Daughter Card
1. captive screw sockets (2)
2. connector on the system board
3. captive screws (2)
4. touch point
5. network daughter card
6. back panel slot for RJ-45 connectors
Installing The Network Daughter Card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1.
Angle the card so that the RJ-45 connectors fit through the slot in the back panel.
2.
Align the captive screws at back-end of the card with the captive screw sockets on the system board.
3.
Press the touch point on the card until the card connector is firmly seated on the system board connector.
4.
Using a #2 Phillips screwdriver, tighten the two captive screws to secure the network daughter card to the system
board.
5.
If applicable, install the expansion card(s) in the expansion-card riser 2.
6.
Close the system.
7.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Processors
Use the following procedure when:
•
Installing an additional processor
•
Replacing a processor
71