Control panel, Removing the control panel – Dell PowerVault NX3200 User Manual
Page 90
7.
Install both the hard drives in their original location.
8.
Close the system.
9.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Control Panel
Removing The Control Panel
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1.
If installed, remove the front bezel.
2.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
3.
Open the system.
CAUTION: Do not use excessive force when removing the control panel cable as it can damage the connectors.
4.
Disconnect the control panel cable from the backplane by pulling on the pull tab.
5.
Remove the three Torx screws that secure the I/O panel to the chassis.
6.
Fold the pull tab close to the connector.
7.
Pull out the control panel cable as you guide the connector and the pull tab through the channel on the chassis.
Figure 48. Removing and Installing the Control Panel
1. Torx screws (3)
2. control panel
90