Removing the vflash media unit – Dell PowerVault NX3200 User Manual
Page 64
Figure 30. Removing and Installing the SD vFlash Card
1. SD vFlash card
2. SD vFlash card slot
3.
To install the SD vFlash card, with the label side facing up, insert the contact-pin end of the SD card into the card
slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the card.
4.
Press inward on the card to lock it into the slot.
Removing The vFlash Media Unit
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
2.
Open the system.
3.
Remove the screw securing the vFlash media unit to the chassis.
4.
Remove the cable from the vFlash media unit and the backplane.
5.
Slide the vFlash media unit toward front of chassis and lift it out of the system.
6.
Close the system.
7.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
64