Dell XPS 710 H2C - Manual (Page 29)

Removing and Installing Parts: Dell XPS 710 H2C Edition Service Manual
file:///C|/Preeji_working%20folder/Projects/E-Doc/Dimension%20and%20XPS/xps-710-h2c/SM/parts.htm[3/13/2013 11:45:23 AM]
1 release tab 2 card retainer 3 alignment guide
4 fan bracket
6. Press the release tab (if present) on the system board connector as you grasp the card by its top corners, and then
ease the card out of the connector.
NOTE: If the card is full-length, press the release tab on the end of the alignment guides on the fan bracket.
1 PCI Express x16 card 2 securing tab 3 PCI Express x16 card slot
7. Install a filler bracket in the empty card-slot opening. If you are replacing the card, see Installing PCI and PCI Express
Cards .
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the
computer. The brackets also keep dust and dirt out of your computer.
NOTICE: Before rotating the card retainer back into place, ensure that the tops of all cards and filler brackets are flush
with the alignment bar and the notch in the top of each card or filler bracket fits around the alignment guide.
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer
cover from closing properly or cause damage to the equipment.