Dell XPS 710 H2C - Manual (Page 30)

Removing and Installing Parts: Dell XPS 710 H2C Edition Service Manual
file:///C|/Preeji_working%20folder/Projects/E-Doc/Dimension%20and%20XPS/xps-710-h2c/SM/parts.htm[3/13/2013 11:45:23 AM]
8. Rotate the card retainer back into its original position; push its tip so that its tab clicks into place.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable into
the computer.
9. If present, lower the card retention device that lays over the installed cards and snap it into place.
10. Replace the computer cover (see Replacing the Computer Cover ), reconnect the computer and devices to electrical
outlets, and then turn them on.
11. Uninstall the driver for the card that you removed.
NOTE: If you removed a sound card or a network adapter, see Network Adapter and Sound Card Settings .
Installing PCI and PCI Express Cards
NOTICE: To avoid electrostatic discharge and damage to internal components, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface on the computer chassis.
NOTICE: If your computer came with a PCI graphics card installed, removal of the card is not necessary when
installing additional graphics cards; however, the card is required for troubleshooting purposes. If you remove the card,
store it in a safe and secure location.
NOTICE: If you have or are upgrading to the optional dual-graphics configuration, see Installing a PCI Express
Graphics Card in a Dual Configuration to install a graphics card.
1. Follow the procedures in Before You Begin .
2. Remove the computer cover (see Removing the Computer Cover ).
3. If present, press the tab on the card retention device that lays over the installed cards and rotate it upwards to gain
full access to the card.
4. Press down the tab on the top of the card retainer at the appropriate card slot and pivot the card retainer back through
the chassis wall.