Installing a pci express, Graphics card in a dual configuration – Dell XPS 710 H2C User Manual
Page 34
Removing and Installing Parts: Dell XPS 710 H2C Edition Service Manual
file:///C|/Preeji_working%20folder/Projects/E-Doc/Dimension%20and%20XPS/xps-710-h2c/SM/parts.htm[3/13/2013 11:45:23 AM]
NOTE:
If the card is full-length, press the release tab on the end of the alignment guides on the fan bracket.
1
PCI Express x16 card
2
securing tab
3
PCI Express x16 card slot
8. Install a filler bracket in the empty card-slot opening. If you are replacing the card, see
Graphics Card in a Dual Configuration
.
NOTE:
Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the
computer. The brackets also keep dust and dirt out of your computer.
NOTE:
The graphics card bridge (not present in all dual-graphics configurations) is not necessary in a single
graphics card configuration.
NOTICE:
Before rotating the card retainer back into place, ensure that the tops of all cards and filler brackets are flush
with the alignment bar and the notch in the top of each card or filler bracket fits around the alignment guide.
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer
cover from closing properly or cause damage to the equipment.
9. Rotate the card retainer back into its original position; push its tip so that its tab clicks into place.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug the cable into
the computer.
10. If present, lower the card retention device that lays over the installed cards and snap it into place.
11. Replace the computer cover (see
), reconnect the computer and devices to electrical
outlets, and then turn them on.
Installing a PCI Express Graphics Card in a Dual Configuration
NOTE:
To upgrade to or downgrade from a dual-graphics configuration, you will need additional parts that can be
ordered from Dell (see Contacting Dell).
This section pertains to dual PCI Express graphics card configurations only. For installation of other types of PCI or PCI
Express cards, see
Installing PCI and PCI Express Cards
.
The PCI Express x1 card slot is not available for use if a graphics card is installed in each of the PCI Express x16 card slots in
a dual graphics card configuration. If you are upgrading from a single graphics card to a dual-graphics card configuration, you
will need to remove any card installed in the PCI Express x1 card slot (see
Express x1 card slot). To remove a PCI Express card, see
Removing PCI and PCI Express Cards
NOTICE:
For information about upgrading your system to use dual-graphics technology, see the Dell website at
support.dell.com.
To learn more about dual-graphics technology, see "Understanding Dual Graphics Technology" in your Owner's Manual.