Dell XPS 710 H2C - Manual (Page 41)

Removing and Installing Parts: Dell XPS 710 H2C Edition Service Manual
file:///C|/Preeji_working%20folder/Projects/E-Doc/Dimension%20and%20XPS/xps-710-h2c/SM/parts.htm[3/13/2013 11:45:23 AM]
6. Replace the computer cover (see Replacing the Computer Cover ).
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
7. Connect the computer and devices to electrical outlets, and turn them on.
Installing a Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
1. Follow the procedures in Before You Begin .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Remove the existing hard drive, if applicable (see Removing a Hard Drive ).
NOTE: If a hard-drive bracket is installed inside of the hard-drive bay, remove the bracket before you install the
new hard drive.
4. Prepare the new hard drive for installation and check the documentation for the hard drive to verify that the drive is
configured for your computer.
NOTE: If hard drive you are installing does not have the hard drive bracket attached, use your original hard
drive bracket; snap the bracket onto the new drive.
1 hard drive 2 hard drive bracket
5. Verify that the hard-drive bay is empty and unobstructed.
6. Slide the hard drive into the hard-drive bay until it clicks securely into place.