Dell XPS 710 H2C - Manual (Page 52)

Removing and Installing Parts: Dell XPS 710 H2C Edition Service Manual
file:///C|/Preeji_working%20folder/Projects/E-Doc/Dimension%20and%20XPS/xps-710-h2c/SM/parts.htm[3/13/2013 11:45:23 AM]
1 drive release latch 2 CD/DVD drive
6. Replace the drive panel (see Replacing the Drive Panel ).
7. Replace the computer cover (see Replacing the Computer Cover ).
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
8. Connect the computer and devices to electrical outlets, and turn them on.
Installing a CD/DVD Drive
1. Follow the procedures in Before You Begin .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Remove the drive panel (see Removing the Drive Panel ).
4. Remove the existing CD/DVD drive, if applicable (see Removing a CD/DVD Drive ).
5. Prepare the CD/DVD drive for installation and check the documentation that accompanied the drive to verify that the
drive is configured for your computer.
NOTE: If you are installing an IDE drive, configure the drive for the cable select setting.
6. If no screws are attached to the drive, check the inside of the drive panel for screws and, if screws are present, attach
the screws to the new drive.