Dell PowerVault MD3220i User Manual

Page 60

Advertising
background image

60

Appendix—Manual Configuration of iSCSI

3 To enable ICMP PING responses for all ports, select Enable ICMP PING

responses.

4 Click OK when all iSCSI storage array port configurations are complete.
5 Test the connection by performing a ping command on each iSCSI storage

array port.

Step 3: Perform Target Discovery From the iSCSI

Initiator

This step identifies the iSCSI ports on the storage array to the host server.

Select the set of steps in one of the following sections (Microsoft Windows or

Linux) that corresponds to your operating system.
If you are using Microsoft Windows Server 2003 or Windows Server 2008 GUI

version:

1 Click StartProgramsMicrosoft iSCSI Initiator or click StartAll

ProgramsAdministrative ToolsiSCSI Initiator.

2 Click the Discovery tab.
3 Under Target Portals, click Add and enter the IP address or DNS name of

the iSCSI port on the storage array.

4 If the iSCSI storage array uses a custom TCP port, change the Port

number. The default is 3260.

5 Click Advanced and set the following values on the General tab:

Local Adapter—Must be set to Microsoft iSCSI Initiator.

Source IP—The source IP address of the host you want to connect

with.

Data Digest and Header Digest—Optionally, you can specify that a

digest of data or header information be compiled during transmission

to assist in troubleshooting.

CHAP logon information—Leave this option unselected and do not

enter CHAP information at this point, unless you are adding the

storage array to a SAN that has target CHAP already configured.

NOTE:

IPSec is not supported.

book.book Page 60 Sunday, September 11, 2011 10:24 PM

Advertising
This manual is related to the following products: