Dell C3765dnf Color Laser Printer - Manual (Page 62)

60 Installing Optional Accessories
5 Select Advanced, and then select a connection method from WPS-PBC, WPS-PIN, Operator Panel, Ethernet
Cable, or Dell Printer Configuration Web Tool.
For
Ethernet Cable:
a Select Ethernet Cable, and then click Next.
Follow the on-screen instructions to configure wireless settings, and then click
Next.
The Advanced Configuration Tool starts.
b Select the printer, and then click Next.
Wireless Network Settings screen appears.
NOTE: If the printer is not listed, click Enter IP Address and enter the IP address of your printer, and then click OK.
c Set the wireless network settings, and then click Next.
IP Address Settings screen appears.
NOTE: For details on each item, see "Assigning an IP Address."
d Set the IP address settings of the printer, and then click Next.
Confirm the settings screen appears.
e Confirm the settings, and then click Apply.
Complete configuration screen appears.
f Click Next.
For WPS-PBC, WPS-PIN, Operator Panel, and Dell Printer Configuration Web Tool, follow the on-screen
instructions to configure wireless settings.
To configure wireless settings without using the video instructions, see the following instructions.
WPS-PIN
The PIN code of WPS-PIN can only be configured from the operator panel.
NOTE: WPS-PIN (Wi-Fi Protected Setup-Personal Identification Number) is a method to authenticate and register devices
required for wireless configuration by entering PIN assignments to a printer and computer. This setting, performed through an
access point, is available only when the access points of your wireless router supports WPS.
1 Press the (Information) button.
2 Select the Tools tab, and then select Admin Settings.
3 Select
until Network appears, and then select Network.
4 Select until Wireless appears, and then select Wireless.
5 Select until WPS Setup appears, and then select WPS Setup.
6 Select PIN Code.
7 Write down the displayed 8-digit PIN code or select Print PIN Code. The PIN code is printed.
8 Select Start Configuration.
9 Ensure that the message Setting WPS is displayed, and enter the PIN code displayed on step 7 into the wireless
LAN access point (Registrar).
NOTE: For WPS operation on the wireless LAN access point, refer to the manual supplied with the wireless LAN access
point.
10 When the WPS operation is successful and the printer is rebooted, wireless LAN connection setting is completed.