Dell PRECISION 530 - Manual (Page 123)

Removing and Installing Parts 123
Re m o v i n g t h e M i c r o p r o c e s s o r
4 Install the new microprocessor in the socket:
a Ensure that the lever on the microprocessor socket is fully
extended to the release position.
NOTICE: When you place the microprocessor in the socket, ensure that the
microprocessor aligns properly with the socket. To avoid damage, you must
position the microprocessor correctly in the socket.
b Align pin 1 of the new microprocessor with pin 1 of the socket.
NOTE: Pin 1 of the microprocessor is indicated by a small triangle in one
corner of the microprocessor. Pin 1 of the socket is indicated by a small
triangle in one corner of the socket. See "
Installing the Microprocessor ."
NOTICE: The microprocessor pins are delicate. To avoid damage, ensure that
the microprocessor aligns properly with the socket, and do not use excessive
force when installing the processor.
c Carefully set the microprocessor in the socket and press it down
lightly to seat it.
microprocessor
microprocessor socket
socket lever