Removing a vrm – Dell PRECISION 530 User Manual
Page 126
Advertising
126
Removing and Installing Parts
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
VRM
NOTICE:
installed. To
locate the VRM and microprocessor sockets, see "
or the interior service label.
Removing a VRM
CAUTION:
Before you perform this procedure, see "
NOTICE:
Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see "
" or the interior service label.
1
.
2
Press the securing clips at each end of the socket outward
simultaneously until the module pops out slightly from the socket (see
the following figure).
3
Lift the module away from the socket.
Advertising