Replacing the 1394 card – Dell Precision M2400 (Mid 2008) User Manual
Page 3
Replacing the 1394 Card
1.
Insert the 1394 card at a 45-degree angle to fit the connector into the base assembly. Use the alignment pins to seat into position.
2.
Replace the two M2 x 3 screws.
3.
Route and connect the 1394 cable to the system board.
4.
Replace the card cage (see
Replacing the Card Cage
).
5.
Replace the palm rest assembly (
Replacing the Palm Rest Assembly
).
6.
Replace the right speaker grill (see
Replacing the Right Speaker Grill/Fingerprint Reader Assembly
).
7.
Replace the keyboard (see
Replacing the Keyboard
).
8.
Replace the LED cover (see
Replacing the LED Cover
).
9.
Replace the display assembly (see
Replacing the Display Assembly (E6400 and M2400)
or
Replacing the Display Assembly (E6400 ATG)
).
10.
Replace the heatsink assembly (see
Replacing the Processor Heatsink Assembly
).
11.
Replace the hinge covers (see
Replacing the Hinge Covers
).
12.
Replace the modular drive (see
Replacing the Modular Drive
).
13.
Replace the bottom of the base assembly (see
Replacing the Bottom of the Base Assembly
).
14.
Follow the procedures in
After Working on Your Computer
.
Back to Contents Page
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.